|
Now that it rolls take it apart for final welds to all the brackets and start the front cross member fabrication.
Date: 09/22/2012
Views: 522
|
2012-09-22_17-21-47_915
Used Brains idea and trashed the original cross member and made a C channel out of square tubing for the new cross member to add a few inches of drop.
Date: 09/22/2012
Views: 948
|
2012-09-22_17-21-38_529
Side angle before I cleaned it up with a grinder
Date: 09/22/2012
Views: 975
|
|
2012-10-14_20-09-39_921
Radius rods installed with leaf spring all set up and ready to go.
Date: 10/14/2012
Views: 969
|
2012-10-14_20-10-08_148
Front shot of the cross member, but I still need to add the frame horns.
Date: 10/14/2012
Views: 953
|
IMG_20130218_125346_349
Body mounts made, and installed. Holes had to be off center because of how the plates fit under the body.
Date: 02/18/2013
Views: 991
|
|
IMG_20130218_125327_568
Side shot of body mounts.
Date: 02/18/2013
Views: 959
|
IMG_20130218_165343_533
Mounted bitches!
Date: 02/18/2013
Views: 920
|
IMG_20130224_211904_593
Time to dangle the engine in the spot and size up some mounting ideas.
Date: 02/24/2013
Views: 921
|
