|
20140921_065517
No glass, trunk has pins.... which are good. Not the way they are installed, but I'll fix that.
Date: 09/21/2014
Views: 822
|
20140927_095605
Under-side of "motor mount". I don't think it would hold a small block.
Date: 09/27/2014
Views: 866
|
20140927_182446
These are the stops for the tilt front end.......
Date: 09/27/2014
Views: 783
|
|
Gasser-15
Good: Has a straight axle, tilt front end and paint job.... not a "good" paint job, just looks nice. You know, a 50/50 paint job. Looks good at 50 feet while driving 50mph.
Date: 09/27/2014
Views: 860
|
20141004_144256
Now to start: Removed crappy motor mounts
Date: 10/04/2014
Views: 852
|
20141102_135950
Made new mounts for front engine plate for the 383 SBC I have. Will use the TH350 with it and add a dual 4-barrel tunnel ram I also have.
Date: 11/02/2014
Views: 814
|
|
20141005_105714
Remove crappy welded bolts used as stops and made some solid stops for the tilt front end.
Date: 10/05/2014
Views: 800
|
20141122_132550
Trans mount.
Date: 11/22/2014
Views: 814
|
20141102_113438
SBC sitting there. Doesn't look right, but whatever.
Date: 11/02/2014
Views: 799
|
|
20141122_163254
Pulled the 8.5 GM Corporate peg leg rear end and.......
Date: 11/22/2014
Views: 852
|
20141123_151356
and had it re-built with posi and 30 spline axles by JS Gears in HB.
Date: 11/23/2014
Views: 804
|
20141123_151435
Made a new set of slapper bars.
Date: 11/23/2014
Views: 794
|
